Dust collector Fervi 0759
In stock
The Fervi 0759 dust collector is the solution that combines compactness, practicality, and is therefore perfect for all those activities, such as carpentry or craft workshops, where woodworking machinery that creates sawdust and shavings are used. As a service machine, the aspirator cannot carry out long-lasting and continuous activities because its function is to be in use only for short periods during work, even in different points of the laboratory thanks to the trolley it is equipped with.
Equipped with a two-button magnetic switch, the dust collector is switched on and off together with the machinery to which it is connected, so a maximum of two. It is important to keep the safety cap always closed on the buttons because given the small size of the machine, in case of need it acts as an emergency stop button.
It is not possible to replace or empty the bag of the dust collector while it is switched on, and in general the whole machine cannot be opened until it is switched off, this means that the connection to the metalworking machinery or machinery must always be placed first to use machinery and vacuum cleaner.
To empty the bag or clean the filter, after turning off the machinery to which the dust collector was connected and itself, the fastening strap must be unhooked and the bag removed. To reassemble it, simply put it back in its position and close the belt. The suction machine is equipped with an identification plate and information pictograms on the correct behavior during use and maintenance.
Code | R0759 |
Suction diameter | 2 x ø 100 mm |
Air capacity | 2500 m3 / h |
Filtering capacity | 5 micron |
Flow in fabric | Ø 510 mm |
Motor speed | 2950 rpm |
Depression | 1.95 kPa |
Single-phase motor | 230 V 50 Hz 1.5 kW |
Dimensions mm | 840 x 560 H 1800 |
Weight kg | 37 |